Enermax iVektor Review - Cases - Reviews - ocaholic



Reviews > Cases > Enermax iVektor Review

Enermax iVektor Review


Published by Luca Rocchi on 05.03.14 (9835 reads)
Page:
(1) 2 3 4 ... 7 »

iVektor is an ATX case from Enermax. The front panel is made by a large amount of ABS covered by a soft-touch finish that looks very good. Other than that it look like the interior offers good flexibility and other than that no less than seven 2.5 inch drives can be installed. Furthermore there are several possibilities to place radiators. At a very first glance it looks like this could be quite a neat case for gamer and maybe also modder.




  Article in English   Artikel in Deutsch   Article en français   Articolo in italiano




On the following pages we will show you strengths and weaknesses of the Enermax iVektor case.

Page 1 - Introduction Page 5 - Left side
Page 2 - Preview Page 6 - Top / Bottom
Page 3 - Front / Back Page 7 - Conclusion
Page 4 - Right side  






Navigate through the articles
Previous article Enermax Fulmo ST Review BitFenix Prodigy M Review Next article
comments powered by Disqus


©2013 by ocaholic.ch - All rights reserved. Alle Angaben sind ohne Gewähr. ocaholic.ch haftet nicht für Schäden, welche durch Anleitungen etc. entstehen können oder entstanden sind. ocaholic.ch haftet nicht für die Richtigkeit bzw. Vollständigkeit der Artikel/Reviews, News, Berichte, etc. Alle Inhalte sind geistiges Eigentum von ocaholic.ch und dürfen nicht ohne schriftliche Genehmigung kopiert und anderweitig veröffentlicht werden. Texte, Bilder, Grafiken sowie Layouts der Seiten sind urheberrechtlich geschützt.