As far as ventilation is concerned the Hyperion is well thought and inside the case you will find three pre-installed fans. Two of them are located in the top part of the case and the other one
on the back of the enclosure. Furthermore there is the possibility to put two 120/140mm in the front, two 120/140mm in the top and a 120mm fan the rear part of the Hyperion. In addition there are slots available also on the bottom and the side. If you do wish so, you could install a total of nine 120mm fans. If you’re planning on installing a liquid cooler, you’ll find it very easy to place up to two 240 millimeter radiators in this case. However, should you put a 240 millimeter radiator in the front, then it won’t be possible anymore to use a high-end graphics card. The sledge on the right side of the case is also compatible with 240mm radiators, but we would not be using it for that purpose, since removing the side panel becomes rather flimsy in this case.
If you are a friend of the classic air cooling there is enough room in the Hyperion to install tower coolers measuring up to 155 millimeter.
|
Silverstone Sugo SG13 Review 