Review: Lian Li PC-Z60
Published by Marc Büchel on 04.01.12Page:
Left Side
Overview |
|
 |
|
| Like the left side panel also the one on the right side of the case is unspectacular. If you take it off you'll see for example the hard drive cage which is thightened to the case. The hard drive cage it self is hot swap capable. To install a hard drive you need to equip them with rails. Afterwards you can simply slide them in place. On the right side of the case, when you look at it from the front, there are two 120 millimeter fans. They make sure that the five hard drives get perfect cooling. Meanwhile it is standard at Lian Li that they provide 2.5 inch slots for SSD for example. With the PC-Z60 you get two 2.5 inch slots. | |
|
|
|
| A total of eight slot bezels
found their way into the PC-Z60. Each of them is kept in place by Lian
Lis very practical tightening mechanism. Above the slot bezels there is a120
millimeter fan which is mounted that it blows hot out of the case.
Between the 120 millimeter fan and the slots bezels there are two
grommets through which one can route tubes of a water cooling or cables.
In the bottom area of the case there are two rubber coated rails onto which one puts the power supply. In the base plate there are ventilation holes that the power supply gets plenty of fresh air. |
|
| Page 1 - Introduction | Page 5 - Left side |
| Page 2 - Preview | Page 6 - Top / Bottom |
| Page 3 - Front / Back | Page 7 - Temperatures |
| Page 4 - Right side | Page 8 - Conclusion |
Discuss this article in the forums
| Navigate through the articles | |
Review: SilverStone TJ08-E |
Coolermaster CM690 II Advanced USB 3.0
 |
|
|