Layout

As we mentioned in the introduction, the MSI Z97 XPower motherboard comes with a Twin Frozr IV based design. Therefore the PCB has a matte black finish with a few yellow touches on the heatsinks. The heatsinks themselves have been shaped with a lot of attention to detail and come with a matte black colour scheme. Combined, it makes the design unique and good looking. The layout itself has been well thought and there are plenty of useful features, like eight USB 3.0 ports on the back, SATA 6Gbps ports, Wi-Fi, Bluetooth, overclocking features and more.



MSI equipped the Z97 XPower with a 32-phase digital power design with IR3563B ICs from International Rectifier taking care of the CPU VRM. Unlike the previous MPower motherboard (Z77), the Z97 XPower power design has one DRMOS for two phases rather than one DRMOS for one phase. All those solid capacitors are part of MSI's Military Class IV group of components so that is one pretty strong power design.
The memory gets a 3-phase digital power design driven by a UPI uP1606R, which one more phase than usual.


As far as the memory goes, you can find four DIMM-slots on the Z97 XPower motherboard. Officially supported are the DDR3 3200 / 3100 / 3000 / 2800 / 2666 / 2600 / 2400 / 2200 / 2133 / 2000 / 1866 / 1600 / 1333 / 1066 MHz (O.C.). There is enough space between the DIMM-slots and the CPU socket which means that you will not run into any issues with large coolers, even if you choose to install memory with big heatspreaders. Also supported are the Xtreme Memory Profiles (XMP) in version 1.3. Overclocking the memory on this board with old ICs (PSC, BBSE), which are what all overlcockers are still using, is not really nice because of the BIOS not being optimized. On the other hand, overclocking with the new Samsung ICs or the Hynix CFR, BFR, MFR is not bad for gaming and daily use PCs, but not for getting any serious high memory frequency results.


The PCH as well as current converters are being held at adequate temperatures via passive heatsinks. The current converters heatsink is made from a single aluminium block that use one 8mm nickel-plated copper heatpipe. The PCH heatsink has not been integrated into the heatpipe loop and it is quite simple and flat. The cooling blocks have been very well made and also they very firmly attached to the motherboard to provide enough pressure on the components they have to cool down. They are entirely black colored with yellow elements to go well with Twin Frozr IV graphics card cooler design and color choices.

Page 1 - Introduction	Page 4 - Layout
Page 2 - Specs and Delivery	Page 5 - Connectors and I/O
Page 3 - Features	Page 6 - Conclusion